- Home
- Engine Out Refurbishment Project
This connection comes from the bulkhead and connects to a solid rail that runs down the outside of the left hand bank of the engine under the plenum. You can get to it through the left hand wheelhouse.
- Install The Engine Dolly Under The Car
- Remove Subframe Bolts
- Raise The Car Away From The Engine
- Cats and Exhaust Header / Manifold Removal
- Remove ARB and Drive Shaft Heat Shields
- Damper Removal
- Wishbone, Driveshaft and Hub Removal
- Damper Disassembly
- Wishbone Bush Removal
- Driveshaft Disassembly
- Alumnium Hub Carrier Stripdown
- Drive Shaft Refurbishment
- Engine Subframe Removal
- Engine Mount Removal
- Alumninium Hub Refurbishment
- Gearshift Rod Disassembly
- Repaint CV and Clutch Heat Shields
- First Parts Delivery!!!
- Removal and Preparation of Parts for Powder Coating
- Remove, Repaint and Replace Fuel Tank Shield
- Replace Engine Cover Supports
- Repaint the Exhaust Heat Shield
- Engine Block and Gearbox Housing Cleaning
- Air-con Compressor Removal and Repair
- Front of Engine Stripdown - Water Pump and Idler Pulley
- Driveshaft Oil Seal Replacement
- Power Steering Pump Removal And Cleanup
- Cam Cover Removal
- Cleanup inside the Vee
- Crankshaft Pulley Removal
- Re-plating of Components
- Engine Subframe Preparation for Powder Coating
- Oil Tank Refurbishment
- Hub Rebuild
- Assorted Replated Components Reassembly
- Throttle quadrant, trumpet clamps, CV heat shield carriers, and other random bits
- Cambelt Change
- Reinstallation of the Crankshaft Pulley
- The First Batch of Powder Coated Parts Arrives!
- Damper Rebuild
- Cam Cover Finishing
- Wishbone Bush Installation
- PAS Pump and Air Con Pump Reinstallation
- Cam Cover Refitting
- Renewal of Various Small Parts Mostly Mounting Hardware
- Strip Down and Rebuild of The Air Injection Pump and Vacuum Tank
- Powder Coating Special Finishes
- Airbox and Side Panel Rebuild
- Plenum Cover and Header Tank Surround Finishing
- Carbon Canister Refurbishment
- Installing The Engine Back Into The Subframe
- Suspension and Driveshaft Reinstallation
- Damper Reinstallation
- Anti -Roll Bar Reinstallation
- Loom and Coil Pack Reinstallation, CV Boot Heat Shields, Damper Motors
- ABS Sensor Reinstallation
- Brake Discs
- Exhaust Manifold (Header) Refurbishment
- Handbrake, Discs and Calipers
- Replacement Bolts Arrived for the Engine Mounts
- Rebuild State at This Point
- Exhaust Manifold (Header) Installation
- A Quick Check of the Radiators
- Plug Leads and Covers
- Oil Tank Reinstallation
- Clutch Cover Refurbishment
- Idle Air Valve, Cats, Reinstallation, Brake Pipe Repair, and Other Small Jobs
- Engine Reinstallation
- Various Reconnections
- Gearshift Rod Reinstallation
- Final Steps and Drive Out of the Garage
- The Final Bill
Page 18 of 90